Copyright 2017, FLIR Commercial Systems, Inc.
7
2 - Safety
2.1 - Overview
This chapter contains important safety instructions. You must read, understand, and comply with all of
these safety instructions in order to protect both persons and property. The benefits of a safe
installation include increased usability, reliability, and reduced damage to the PTU, payload, and/or
other property.
2.2 - Safety Warnings and Cautions
• PTU installation and setup should be only be performed by qualified personnel.
• The installation must comply with all applicable codes (such as building codes, marine safety codes,
etc.).
• The installation must be free of obstructions throughout the entire range of pan-tilt motion. When
planning the installation, make sure to take the payload into account to ensure that the PTU and
payload remain unobstructed at all times.
• All mounting methods and materials must be capable of supporting at least four times the combined
weight of the PTU, mounted payloads, and cabling.
• Corrosion-resistant hardware (such as stainless steel screws) must be used for all outdoor
installations.
• Do not install the PTU in any location that exceeds the PTU’s environmental specifications.
• Always incorporate a readily accessible power disconnect into the installation wiring. (See “Basic
Setup” on page 10 and “Wiring and Connectors” on page 16.)
• Removing power by disconnecting the power cable or cable harness is not recommended and can
result in damage to the system.
• All service procedures must be performed by qualified service personnel in accordance with all
applicable instructions.
• If the PTU is damaged, immediately remove power and contact FLIR Systems, Inc.
• Only use replacement parts recommended by FLIR Systems, Inc.
• Use caution when lifting the PTU and/or payload.
To Next Page