xiv
CAUTION
Do not subject the SGA to operational airspeeds in excess
of 250 mph (218 knots), as this could cause damage to the
ferrofluidic seals.
CAUTION
Proper grounding of the SeaFLIR II Imaging System must be
accomplished at time of installation into the host platform.
Refer to the FLIR Interface Control Document (ICD),
18400-940. Additional service and installation information
can be obtained by contacting FLIR at (978) 901-8000.
Improper installation of the system will cause display
problems and can damage the system components.
CAUTION
Caution should be exercised at all times when operating the
laser pointer to ensure that personnel are not directly in
front of the laser when it is fired. The laser pointer should
not be used to range on personnel, marine biologics, or
animal life. Do not use magnified optics, such as
binoculars, when working around or in the path of the laser
beam.
CAUTION
Do not use cleaning fluids containing ammonia or acids.
They can damage the optical coatings on the windows. Use
only a soft cotton cloth or lens tissue dampened with
isopropyl alcohol or fresh water.
CAUTION
Do not use high-pressure water or air (over 2 PSI) to clean
the SGA. High-pressure water or air could cause damage to
the ferrofluidic seals located in the azimuth and elevation
axes of rotation. Use a low-pressure fresh water stream not
less than 0.5” diameter or other low pressure cleaning
method.
Commercial in Confidence
Export Level 2
Issued to: AgustaWestland
CM Ref:4049
Valid on Day of Issue only.
Document will not be updated
Uncontrolled : 4256
Retrieval Date:07-Dec-10
Requested by Bower, Richard
To Next Page
Loading...