50
c. Press ADJ Switch.
d. Scroll through the Initial setup menu to Date and time.
e. Press ADJ Switch.
f. Use the Strain Gauge or ZOOM Rocker Switch (up to increase,
down to decrease) to adjust the Date and time fields.
g. After the first position is set, use the FOCUS Rocker Switch to step
to the next position field.
h. Repeat steps f. and g. above to select and change each field.
i. When Date and time changes are complete, press the EXIT Switch
twice to finish and resume normal operation.
Figure 3-32. Date and Time Setup and Edit Display
3.6.3 Advanced Mode
Advanced mode [ ] (default) – Allows access to the two basic Auto-
Tracker modes through the Tracker Mode Switch. The Tracker Mode
Switch is used to step through and select one of the two basic tracker
modes.
Commercial in Confidence
Export Level 2
Issued to: AgustaWestland
CM Ref:4049
Valid on Day of Issue only.
Document will not be updated
Uncontrolled : 4256
Retrieval Date:07-Dec-10
Requested by Bower, Richard
To Next Page
Loading...
Need help?
General
