57
Figure 3-34. Radar Bearing Invalid Data Display
3.9.2 Radar Bearing Single-Shot Mode
In Radar Bearing Single-Shot Mode the SeaFLIR II system must be set
to receive a radar input but need not have Radar Bearing selected when
the Radar Bearing is sent. Notification by the radar operator that he has
target of interest will allow the SeaFLIR II operator to select Radar
Bearing mode and then press the SYM switch to accept the radar
bearing and slew to the target (Figure 3-35). All subsequent ARPA
targets are ignored until the operator chooses to accept the input, Press
SYM Switch, to acquire the next target. An asterisk will show at the right
side (* RAD:ON_LINE * SINGL) when new data is available in Single
Shot mode.
* RAD:ON_LINE * SINGL Pressing SYM switch accepts radar input
and positions Gimbal to the new radar bearing.
3.9.3 Radar Bearing Continuous Mode
In Radar Bearing Continuous Mode the SeaFLIR II system must be set
to Radar Bearing to receive a radar input. The radar continuously
updates the SGA and is slaved to the ARPA (radar) track. When the
SeaFLIR II is slaved to the radar * RAD:ON_LINE CONT will be
Commercial in Confidence
Export Level 2
Issued to: AgustaWestland
CM Ref:4049
Valid on Day of Issue only.
Document will not be updated
Uncontrolled : 4256
Retrieval Date:07-Dec-10
Requested by Bower, Richard
To Next Page
Loading...