EasyManuals Logo

Flowserve NORBRO 40R Series User Manual

Flowserve NORBRO 40R Series
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2 background imageLoading...
Page #2 background image
1 Safety
2 Health and Safety
3 Description
4 Actuator markings
5 Installation
6 Fitting indicators
7 Air supply and installation
8 Air Consumption
9 Installation of accessories
10 Operation
10.1 Basic Actuator
10.2 Actuator With Solenoid
1 SAFETY SYMBOLS
The safety terms DANGER, WARNING, CAUTION
and NOTE are used in these instructions to
highlight particular dangers and/or to provide
additional information on aspects that may not
be readily apparent.
DANGER: indicates that death, severe personal
injury and / or substantial property damage will
occur if proper precautions are not taken.
WARNING: indicates that death, severe personal
injury and / or substantial property damage can
occur if proper precautions are not taken.
CAUTION: indicates that minor personal injury
and / or property damage can occur if proper
precautions are not taken.
NOTE: indicates and provides additional technical
information, which may not be very obvious even
to qualified personnel. Compliance with other,
not particularly emphasised notes, with regard to
transport, assembly, operation and maintenance
and with regard to technical documentation (e.g.
in the operating instruction, product documenta-
tion or on the product itself) is essential, in order
to avoid mistakes, which, in themselves, might
directly or indirectly cause severe personal injury
or property damage.
STOP!
2 HEALTH AND SAFETY
When installing or maintaining actuators:
2.1 Conduct a risk assessment and eliminate or
reduce hazards to an acceptable level.
2.2 Work in accordance with Safe Systems of
Work.
2.3 Observe all site Health and Safety Rules in
particular Permit to Work and Hot Work proce-
dures.
2.4 Wear all necessary Personal Protective Equip-
ment.
2.5 Never remove or maintain an actuator or joint
unless the supply has been fully de-pres-
surised, drained and where necessary, purged
of toxic / explosive / flammable media. Always
operate the actuator to ensure that no trapped
pressure exists.
2.6 Never handle actuators that have been used
on harmful substances unless they have been
completely decontaminated and certified safe
to handle.
2.7 Never use an actuator on a duty, which exceeds
its prescribed operating parameters. Refer to
Flowserve Flow Control Technical Sales for
further information.
2.8 Never modify or alter actuators unless the
manufacturer has been consulted and/or
recommends such changes.
2.9 Due to the large physical size and weight of
some sizes of this product, always use correct
lifting methods and equipment when installing,
Contents
10.3 Standard Stroke Times
10.4 Manual Operation
11 Maintenance
12 Spare Parts
13 Troubleshooting
14 Rebuilding instructions
14.1 Actuator disassembly
14.2 Actuator reassembly
15 Spring-return actuator
16 Size 05 Exploded view/parts/materials
17 Size 10-50 Exploded view/parts/materials

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Flowserve NORBRO 40R Series and is the answer not in the manual?

Flowserve NORBRO 40R Series Specifications

General IconGeneral
BrandFlowserve
ModelNORBRO 40R Series
CategoryController
LanguageEnglish

Related product manuals