Fluke 123 - Charging the Rechargeable Battery Pack

Fluke 123/124
Users Manual
36
The readout shows the voltage difference between the two
cursors and the voltages at the cursors in relation to the
zero icon (-). See Figure 1-19).
Use horizontal cursors to measure the amplitude, high and
low value, or overshoot of a waveform.
Using Vertical Cursors on a Waveform
To use the cursors for a time measurement, do the
following:
c From Scope mode, display the
Cursor Key functions.
d Press to highlight . Observe
that two vertical cursors are
displayed. Markers (-) identify the
point where the cursors cross the
waveform.
e If necessary, choose the trace A
or B.
f Highlight the left cursor.
g Move the left cursor to the desired
position on the waveform.
h Highlight the right cursor.
i Move the right cursor to the
desired position on the waveform.
Figure 1-20. Time Measurement with Cursors