Fluke 123 - Maintaining the Test Tool

Using The Test Tool
Making Cursor Measurements
1
35
Making Cursor Measurements
Fluke 124 has cursors. Cursors allow you to make precise
digital measurements on waveforms.
Using Horizontal Cursors on a Waveform
To use the cursors for a voltage measurement, do the
following:
c
From Scope mode, display the
Cursor Key functions.
d Press to highlight . Observe
that two horizontal cursor lines
are displayed.
e Highlight the upper cursor.
f Move the upper cursor to the
desired position on the screen.
g Highlight the lower cursor.
h Move the lower cursor to the
desired position on the screen.
Note
Even when the key labels are not displayed at the
bottom of the screen, you can still use the arrow
keys.
Figure 1-19. Voltage Measurement with Cursors