Fluke 1523 - Page 56

49
Digital Communication Interface
Serial Commands - Alphabetic Listing
●
For query commands, specifying the MIN, MAX, or DEF parameter causes
the instrument to respond with the minimum, maximum, or default setting
respectively.
●
For set commands, specifying the MIN, MAX, or DEF parameters causes the
instrument to use the minimum, maximum, or default setting respectively.
●
‘|’ indicates alternate parameter values.
●
<n> indicates a number is required.
●
<prb> indicates a probe number (1 or 2) is required.
●
<num> indicates numeric value is required.
●
<bool> indicates a Boolean value (0 or 1) is required. The mnemonics OFF and
ON are also accepted for 0 and 1, respectively.
●
<conv> indicates a conversion mnemonic is required.
●
<param> indicates a parameter name is required.
●
<seri> indicates a serial number is required.
●
<unit> indicates a temperature unit is required.
●
<temp> indicates a temperature °C/F is required.
●
<pass> indicates a password is required.
●
<port> indicates a port number is required.
●
<label> indicates an eight character label is required.
●
<year> indicates a four digit number is required.
●
<month> indicates a one or two digit number is required.
●
<day> indicates a one or two digit number is required.
●
<hour> indicates a one or two digit number is required.
●
<minute> indicates a one or two digit number is required.
●
<second> indicates a one or two digit number is required.
●
<baud> indicates a valid baud number is required.
*CLS
Clear the event registers and the error queue.
Example: *CLS
This command has no response.
*IDN?
Returns the instrument identication string that indicates the manufacturer, model
number, serial number, and rmware version.
Shop for Fluke products online at:
1.877.766.5412
www.MyFlukeStore.com