3 Phase Power Quality Analyzer
Energy Analyze Plus Software
21
How to Connect to Energy Analyze Plus
The Analyzer supports these interfaces to connect to the PC:
USB cable
Ethernet
WiFi - direct connection
WiFi - connection to infrastructure
Note
After the connection is established, Energy Analyze Plus software shows the Analyzer
in the list of found devices. Choose the Analyzer to setup and/or download
measurement data from.
USB Cable
To connect the PC to the Analyzer:
1. Turn on the computer and the Analyzer.
2. Make sure Energy Analyze Plus Software is installed. The software installation also installs
the required drivers.
3. Connect the USB cable to the USB ports of the computer and the Analyzer. See Figure 11.
Figure 11. PQ Analyzer to PC Connections
4. The USB cable connection uses a network communication over USB (Remote NDIS
network) with Internet Protocol IPv6. When you connect the Analyzer with the RNDIS
network interface, a serial port “USB Serial Port (COMx)” appears in Windows device
manager. This serial port is for production and service/calibration purposes only.
To Next Page
Loading...
Need help?
General
