CAT III 1500V TRMS Clamp Meter
Maintenance
25
Maintenance
If the Product is used appropriately it does not require special maintenance or repair. In
case of repair, go to www.fluke.com for contact information of Fluke Service Centers
worldwide.
XW Warning
To prevent possible electrical shock, fire, or personal injury:
• Remove the input signals before you clean the Product.
• Repair the Product before use if the battery leaks. Battery leakage may
create a shock hazard or damage the Product.
• Use only specified replacement parts.
• Have an approved technician repair the Product.
• Remove the batteries if the Product is not used for an extended period of
time, or if stored in temperatures above 50 °C. If the batteries are not
removed, battery leakage may result.
Operation Checks
To make sure your Product is good working condition, you can check:
• LCD segments
• Firmware version
• Fluke Connect LED
• LCD for resistance continuity
• LCD for dc polarity
• Backlight
To check LCD segments and firmware version:
1. Turn off the Clamp.
2. Press and hold H + ON (rotate control knob) to any function.
All LCD segments show on the display.
3. Release H.
The firmware version shows on the display.
To Next Page
Loading...
