Fluke 5560A - Set AC Current Output; Set Resistance Output; Set Capacitance Output

Calibrator
Single Output Menu
45
Set AC Current Output
To set the ac current output (Function > Single Output > ACI), refer to Set an Output and the
example shown in Table 13 for output entry basics. The ac current output is at the VI AUX or 30A
terminal to OUTPUT LO.
Also see these sections:
• Guard Softkey
• Sync Button
• Waveform Types
• Adjust Phase - Output to Reference
Set Resistance Output
Note
Since this is a synthesized output, make sure the terminal connections from the Calibrator to
the DUT are LO to LO and HI to HI.
To set a synthesized resistance output at the front-panel OUTPUT terminals (Function > Single
Output > Resistance), refer to Set an Output and the example shown in Table 13 for output entry
basics.
Also see these sections:
• Guard Softkey
• Comp Softkey
Set Capacitance Output
Note
Since this is a synthesized output, make sure the terminal connections from the Calibrator to
the DUT are LO to LO and HI to HI.
To set a synthesized capacitance output at the front-panel OUTPUT terminals (Function > Single
Output > Capacitance), refer to Set an Output and the example shown in Table 13 for output entry
basics.
Also see these sections:
• Guard Softkey
• Comp Softkey