5560A/5550A/5540A
Operators Manual
66
Rack Mount Kit
The Y5538 rack mount kit provides all the hardware necessary to mount the Calibrator in a 24-inch
(61 cm) equipment rack. Instructions are provided in the kit.
IEEE-488 Interface Cable
Shielded IEEE-488 cables are available in three lengths (See Table 19). The cables attach to the
Calibrator to any other IEEE-488 device. Each cable has double 24-pin connectors at both ends to
allow stacking. Metric threaded mounting screws are provided with each connector. See the 5560A/
5550A/5540A Remote Programmers Manual at www.flukecal.com
for the pinout information for the
IEEE-488 connector.
RS-232 Null-Modem Cables
The PM8914/001 and RS40 null modem cables connect the Calibrator RS-232 Serial Port to a video
display terminal, computer, or other serial device configured as DTE (Data Terminal Equipment). See
the 5560A/5550A/5540A Remote Programmers Manual at www.flukecal.com
for the pinouts for the
serial connectors.
55XXA-525A/LEADS
The optional test lead kit, 55XXA-525A/LEADS, is a kit of test leads for voltage and current,
thermocouple extension wires, thermocouple miniconnectors, and thermocouple measuring beads.
To Next Page
Loading...
