EasyManuals Logo

Fluke 719 Series User Manual

Fluke 719 Series
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
Pressure Calibrator with Electric Pump
Introduction
3
Make sure the battery door is closed and
latched before operating the Calibrator.
Do not operate the Calibrator if it is
damaged.
Do not operate the Calibrator around
explosive gas, vapor, or dust.
When using probes, keep fingers behind
the finger guards on the probes.
Use only two 9 V batteries, properly
installed in the Calibrator case, to power
the Calibrator.
Follow all equipment safety procedures.
Turn off circuit power before connecting
the Calibrator mA and COM terminals in
the circuit. Place Calibrator in series with
the circuit.
When servicing the Calibrator, use only
specified replacement parts.
Do not allow water inside the case.
To avoid false readings, which could
lead to possible electric shock or
personal injury, replace the battery as
soon as the battery indicator (B)
appears.
To avoid a violent release of pressure in
a pressurized system, shut off the valve
and slowly bleed off the pressure before
attaching or detaching the internal
pressure sensor or pressure module
fitting to the pressure line.
To avoid over pressure damages, do not
apply pressure that exceeds the limits
listed in the Pressure Specifications
table in the Specifications section.
To avoid mechanically damaging the
Calibrator, do not apply torque between
the pressure fitting and the Calibrator
case. See Figure 1 for the proper use of
tools.
To avoid misleading readings,
disconnect the pressure module
connector at the Calibrator.
To avoid damage to the pressure
module, refer to the related Instruction
Sheet.
To avoid damage to the pump, use with
dry air and non-corrosive gases only.
Check test leads for continuity before
using. Inspect Calibrator for cracks or
damage, do not use the probes if they
are damaged or show high resistance.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fluke 719 Series and is the answer not in the manual?

Fluke 719 Series Specifications

General IconGeneral
Accuracy0.025% of full scale
Current Measurement0 to 24 mA
DisplayLCD
Pressure MediaNon-corrosive gases
Pressure Unitspsi, bar, kPa
Resolution1 µA
Loop Power24V DC
Operating Temperature-10 °C to 55 °C
Storage Temperature-20 °C to 60 °C
Weight0.65 kg

Related product manuals