Pressure Calibrator
Menus
23
The standard probe has a 10-inch insertion depth with a
¼-inch diameter stainless steel sheath. See Figure 5.
Note
The factory default type is PT100-385 so if the
Product is used with the Fluke 720 RTD Probe
(pn 4366669), it is not necessary to set the
probe type. Connect the probe to the Product
and configure the display to read temperature.
The display shows “OL” when the measured
temperature is outside the nominal
measurement range of the RTD function (below
-40
°
C or above 150
°
C).
30V
24mA
MAX
V
mA
COM
F1 F2 F3
ZERO
RTD Probe
hmq016.eps
Figure 5. Temperature Measurement with RTD Probe
To Next Page
Loading...
