Need help?Do you have a question about the Fluke DTX Series and is the answer not in the manual?
General| Category | Cable Analyzer |
|---|---|
| Interface | USB |
| Power Source | Battery or AC adapter |
| Battery | Lithium Ion |
| Cable Types Tested | Fiber |
| Test Standards | ISO |
| Battery Life | Up to 12 hours |
| Operating Temperature | 0°C to 50°C |
| Storage Temperature | -20°C to 60°C |
Explains how to set the baseline for insertion loss, ACR-F, and DC resistance measurements.
Guides users on performing autotests for twisted pair cabling, including setup and connection procedures.
Describes the Autotest Summary screen, explaining PASS, FAIL, and PASS*/FAIL* indicators.
Details how to access diagnostic information for failed autotests and provides examples of common failure screens.
Explains how to set the baseline for insertion loss measurements for coaxial cabling tests.
Guides users on performing autotests for coaxial cabling, covering setup and connection procedures.
Describes the Autotest Summary screen for coaxial tests, explaining PASS and FAIL indicators.
Guides users on how to test network connectivity using DHCP or Static mode and connecting to the network.
Details the process of updating the tester's software using the LinkWare software and a PC connection.
To Next Page
