Fluke DTX Series - Installing and Removing the Network Module and Optional SFP Module

Verifying Network Service
43
Installing and Removing the Network Module and
Optional SFP Module
Install the network module only in the main tester. See
Figure 22. Install an optional SFP (small form pluggable)
module to test fiber links. You may install or remove the
SFP module while the tester is on.
W
Caution
Leave the module bay cover in place when a
module is not installed.
Put the dust cap on the SFP port when an
optical module is not installed. Put the dust cap
on the optical module when not connected to a
fiber.
amd39f.eps
Figure 22. Installing and Removing the Network and SFP Modules