Fluke DTX Series - Autotest Summary Results for Twisted Pair Cabling

Certifying Twisted Pair Cabling
29
Autotest Summary Results for Twisted Pair Cabling
Figure 13 describes the Autotest Summary screen.
Figure 13. Autotest Summary for Twisted Pair Cabling
amd77f.eps
A PASS: All parameters are within limits.
FAIL: One or more parameters exceed the limit.
PASS*/FAIL*: One or more parameters are within the tester’s
accuracy uncertainty range, and the “*” notation is required by the
selected test standard. See “PASS*/FAIL* Results” on page 30.
B Press K or L to scroll the screen.
C If the test failed, press J for diagnostic information.
D Action prompt for the screen. Use D A to highlight a
parameter; then press H.
E E: The test passed.
i: The parameter was measured, but has no PASS/FAIL limit in the
selected test limit.
X: The test failed.
U: See “PASS*/FAIL* Results” on page 30.
F The worst margin found for the test.