Fluke DTX Series - Identifying Links (Twisted Pair Only)

DTX Series CableAnalyzer
Users Manual
52
Identifying Links (twisted pair only)
The ID Locator function helps you quickly identify link
connections at a patch panel. This function requires one or
more optional Fluke Networks LinkRunner
™
Cable ID
locators.
Note
ID locator results cannot be saved.
1 Connect the tester and ID locator(s) as shown in Figure
27.
2 Turn the rotary switch to MONITOR, select ID Locator;
then press P.
3 Connect the tester to different jacks, pressing P to
rescan each time, until Found Cable ID and the
identifier’s number appears.
Note
Wiring faults may cause the tester to misidentify
the ID locator’s number, or prevent the tester from
detecting the locator.