Fluke DTX Series - Updating with Another Tester

DTX Series CableAnalyzer
Users Manual
66
Updating with Another Tester
You can update a tester’s software using another tester
that is already updated.
1 Use link interface adapters to connect an updated
tester or smart remote to a tester or smart remote that
needs updating (Figure
29).
Note
One of the testers must be a main tester.
2 Turn on both testers. The testers compare software
versions. If one has more recent software, the main
tester prompts you about updating the older
software.
3 Press K OK to start the update process.
4 To verify the update, turn the rotary switch to SPECIAL
FUNCTIONS; then select Version Information.
amd73f.eps
Figure 29. Updating the Software with an Updated
Teste r
TEST
LOW BATTERY
TONE
TALK
FAIL
TEST
PASS
TALK
TALK
MONITOR
ENTER
TEST
SAVE
SPECIAL
FUNCTIONS
SETUP
AUTO
TEST
SINGLE
TEST
EXIT
F1 F2
F3
TALK
MONITOR
ENTER
TEST
SAVE
SPECIAL
FUNCTIONS
SETUP
AUTO
TEST
SINGLE
TEST
EXIT
F1 F2
F3
TALK
MONITOR
ENTER
TEST
SAVE
SPECIAL
FUNCTIONS
SETUP
AUTO
TEST
SINGLE
TEST
EXIT
F1 F2
F3