Fluke Performance Series - Voice Annotation; Listen to a Voice Annotation

Ti90, Ti95, Ti100, Ti105, Ti110, Ti125, TiR105, TiR110, TiR125
Users Manual
18
Voice Annotation
The maximum recording time is 60 seconds for each image reviewable
playback (varies by model).
To add a voice (audio) record:
1. With an image in the buffer, push  to open the EDIT IMAGE menu.
2. Push / to highlight Add Audio.
3. Push  to record up to 60 seconds of audio. The display updates to
show the recorded time.
4. Push  to pause the recorder.
5. Push  when done.
6. Push  to review the audio file or  to save the audio with the
image.
Listen to a Voice Annotation
The voice (audio) record replays through the speaker.
To playback an .is2 file on the SD memory card:
1. Do the steps in the Review Data Files section on page 48 to see the image
on the display.
2. Push .
3. Push  or  to set Audio.
4. Push  to listen to the audio.
5. Push  again to pause the audio.
Shop for Fluke products online at:
1.877.766.5412
www.MyFlukeStore.com