Fluke TS52PRO - Accessories and Specifications

23
Maintenance
4 Insert the plastic clip over the line cord strain relief
at the base of the test set housing (Figure 7) and
press tightly into place. Inspect all work to ensure
no pinched wires or areas where weather
resistance and safe operation is affected. Reinstall
the battery. Observe the proper polarity.
5 Place the battery door cover on the test set and
fasten the four screws (Figure 4). Tighten screws to
a maximum torque of 0.904 N-m or 8 in-lb.
bfp08.eps
Figure 8. Removal/Installation of Line Cord
Screw Lugs
bfp09.eps
Figure 9. Orientation of Line Cord Screw Lugs
Accessories (How to Order)
To order accessories, contact your local Fluke Networks
distributor.
Screw Lug
Note:
Speaker not
shown for
illustration
purposes.
Red line cord
Black line cord
Description Model Number
Belt clip, lockable (both ends) P4080248
Belt clip, non-lockable (both
ends)
P4080249
Standard Line Cord with Piercing
Pin Clips
P4480001
Central Office Line Cord with
346A Plug
P4480004
Angled Bed-of-Nails Cord (ABN)
and Piercing Pin Clips
P4480009
Angled Bed-of-Nails Cord (ABN)
with Piercing Pin Clips and with
RJ-11 Plug
P4480RJ9
TS52PRO Test Set with 4 mm
banana leads with extra-large
alligator clips and test probes
52801TNT
Replacement Cord, 4 mm banana
leads with extra-large alligator
clips and test probes
P4480TNT