2
TS52PRO Test Set
Users Guide
Safety Information
The following IEC symbols are used either on the test
set or in the manual:
WWarningX
To avoid possible fire, electric shock, or personal
injury:
•
Read all of the safety information in the test set
Users Guide before you use the product.
•
Do not use test leads if they are damaged.
Examine the test leads for exposed metal and
damage to the insulation. Make sure the wear
indicator on the cords does not show. The wear
indicator is the white layer below the outer,
braided layer. Verify the continuity of the test
leads.
•
Do not exceed the Measurement Category (CAT)
rating of the lowest-rated individual component
of a product, probe, or accessory.
•
Keep your fingers behind the finger guards on
the probes.
•
Do not use the test set if it is damaged. Before
you use the test set, inspect the case. Look for
cracks or missing plastic. Pay particular attention
to the insulation surrounding the connectors.
•
Do not use around explosive gases or vapors, or
in a damp or wet environment when hazardous
voltage is present.
•
The test set meets IEC Measurement Category I
standard. CAT I equipment is designed to protect
against transients in equipment on circuits not
directly connected to MAINS. Under no
circumstances should the line cord of the test set
be connected to any CAT II, CAT III, or CAT IV
rated circuit.
•
If this product is used in a manner not specified
by the manufacturer, the protection provided by
the product may be impaired.
Product Features
•
Liquid Crystal Display with backlight
•
Caller ID
•
DataSafe
™
in Monitor mode
•
Data detection and lockout in Talk mode
•
Data lockout override
•
DTMF digit grabbing
•
High impedance in Monitor mode
•
High voltage protection
•
Last number redial up to 23 digits
•
Visual ANAC mode
•
Microphone mute
•
Pause key
•
Reverse polarity indication
•
Two-way speakerphone
•
Receive-Only Loud Speaker
•
Speed dialing for ten 23-digit numbers
•
Tone and pulse dialing
•
Hook flash
•
Line voltage / Loop current test
•
Low battery indication
•
Relocatable belt clip
•
Field-replaceable belt clip, battery, and line cord
•
Weatherproof case
W
Warning: Risk of personal injury. See the
manual for details.
Caution: Risk of damage or destruction to
equipment or software. See the manual
for details.
X
Warning: Risk of electric shock.
;
Conforms to relevant Australian EMC
requirements.
)
Conforms to relevant Canadian and US
standards.
P
Conforms to European Union directives.
T
Double Insulated - does not require
connection to earth ground.
~
Do not put products containing circuit
boards into the garbage. Dispose of circuit
boards in accordance with local
regulations.
To Next Page
Loading...
Need help?
General
