4.2. Arming
SPINNING PROPELLERS CAN CAUSE SERIOUS INJURIES. DO NOT HAVE ANY BODY PART
INSIDE THE CAGE WHILE ARMING THE DRONE.
When the battery is connected and the power button has been pressed, ELIOS 3 is switched on and in standby
mode. The aircraft must be armed before takeoff.
Place the 3 position switch of the GCS on the C1 position ASSIST MODE.
To arm ELIOS 3, perform the following arming sequence in rapid succession:
1. Place the left stick on the bottom right.
2. Keeping the left stick down, slide it to the bottom left.
3. Slide back the left stick to the bottom right.
Figure 4.2: Arming sequence
Once armed, ELIOS 3 will power on its motors and be able to take off.
To Next Page
Loading...
