Flyer GOROC User Manual

123
EN
The following electrical support levels are available:
• "OFF": The electrical support is switched OFF
and the e-bike can be moved by pedalling only,
like a normal bicycle. All other functions (e.g.
lighting) are still available.
• "ECO": Effective electrical support with maxi
-
mum efciency to achieve maximum range
• "TOUR": Continuous electrical support for
trips with a large range
• "SPORT": Powerful electrical support for ath
-
letic riding on mountainous routes as well as
in city trafc
• "TURBO": Maximum electrical support up to
high pedalling frequencies for athletic riding
To increase the support level, continue to press
the button «+» 13 on the operating unit until the
desired support level is displayed in eld ‘b’. To de
-
crease the support level, press the button «–» 12.
The requested motor performance will be shown
in eld ‘a’. The maximum motor performance de
-
pends on the electrical support level chosen.
10. Control panel
11. The display function button«i» on the
operating unit
12. Reduce assistance/scroll down button «–»
13. Increase assistance/ scroll upwards button «+»
14. Button for pushing assistance «WALK»
Switching the pushing/ start-up aid on and off
The pushing/ start-up aid can make it easier for
you to push the e-bike or get it moving.
FLYERS with pedalling support up to 25 km/h are
equipped with a pushing aid.
This is limited to 6 km/h in the fastest gear. The
FLYER can conveniently be moved out of under
-
ground parking or along steep paths by pressing
the bicycle button 14. The bicycle button allows
models with pedalling support above 25 km/h to
activate the start-up aid, which is restricted to 18
km/h. The installation is performed in compliance
with national regulations.
14
13
11
10
12
The pushing aid is switched on by pressing the
"WALK" 14 button on the operating unit and hold
-
ing it down. The e-bike electrical support function
is switched on. The pushing aid is switched off as
soon as one of the following events occurs:
• You release the "WALK" 14 button,
• The wheels of the e-bike are blocked (e.g. by
breaking or bumping against an obstacle)
• speed exceeds 6 km/h or 18 km/h
Do not use the pushing aid to ride the
bike.
Switch lighting on/off
The headlight and the rear light can be switched on
and off at the same time by pressing the 2 button
on the controls when the respective bicycle version
supplies the riding lights from the e-bike system.
Gear Recommendation
If the notication "g" is displayed , you should shift
into a higher gear and pedal at a lower cadence. If
the notication “h ” is displayed , you should shift
into a lower gear and pedal at a faster cadence.
Battery charge status indicator
The battery charge status indicator i shows the
charge status of the e-bike battery and not that
of the internal controls’ battery. The charge status
of the e-bike battery can be read on the battery
itself.
Each bar on the battery symbol i corresponds
to approx. 20% capacity:
The battery is fully charged.
The battery should be topped up.
The charge for electrical support is
used up and the electrical support
function will gently switch off. The
remaining capacity is provided for the
lighting and the controls, the display
ashes. The battery will still provide
approx. 2 hours of lighting.

Flyer GOROC Specifications

General

Brand	Flyer
Model	GOROC
Category	Scooter
Language	English