61
EN
Then turn the handlebars back to the riding posi-
tion (2). The bolt must be re-latched (3).
Completely close the quick-release lever (4).
The Speedlifter quick-release lever must
be completely closed during the ride,
just like any other quick-release fasten
-
er. It must also be ensured that the un-
locking bolt is latched in the front hole.
Never adjust the handlebars while rid
-
ing.
Read the instructions of the component
manufacturer and for more information
visit: www.speedlifter.com.
1
3
2
90°
4
Adjusting the stem
For all stems, please read the instruc-
tions supplied by the manufacturer. Only
allow FLYER specialists to work on the
handlebars and stem.
The following stem types are installed on
FLYERS:
A-head stem
Adjustable stem
The incline of the stem can be adjusted to your re
-
quirements. Depending on the model, the lateral
or internal fastening screw must be loosened and
tightened again after adjustment with the correct
fastening torque.
Changing the position of the stem also
changes the position of the handlebars.
You should always be able to safely
reach and use grips and controls. Han
-
dles with a pronounced wing shape may
need to be repositioned.
Make sure that all cables and leads have
asucientlengthtoallowforallpossible
steering movements when changing the
handlebar and stem position.
Adjustable stem
Fastening screw
To Next Page
