Flyer UPROC - Page 164

11
EN
All repairs must be carried out by an authorised
bicycle retailer.
All repairs must be carried out by an au-
thorised bicycle retailer.
Gear
Recommendation
Ifthenotication“g” is displayed, you should shift
into a higher gear and pedal at a lower cadence.
Ifthenotication“h” is displayed, you should shift
into a lower gear and pedal at a faster cadence.
Batterychargestatusindicator
The battery charge status indicator i shows the
charge status of the E-bike battery and not that of
the internal on-board computer battery.
The charge status of the E-bike battery can be
read on the battery itself.
Each bar on the battery symbol i corresponds to
approx.20%capacity:
The battery is fully charged.
The battery should be topped up.
The charge for electrical support is used
up and the electrical support function
will gently switch o󰀨. The remaining capacity is
provided for the lighting and the controls, the dis
-
play
ashes.Thebatterywillstillprovideapprox.
2 hours of lighting.
Other power consumers (e.g. automatic gears,
chargingofexternaldevicesviatheUSBport)are
not taken into consideration here.
To reset <Route>, <Riding time> and <Aver
-
age>, switch to one of these three functions then
press the
RESET (6) button until the display is
reset to zero. The values of the two other func-
tions are also reset when you do this. To reset
<Maximum>
, switch to this function then press
the RESET (6) button until the display is reset to
zero. To reset <Range>, switch to this function
then press the RESET (6) button until the value
displayed is reset to the default value. If the on-
board computer is removed from the holder (4),
the values of all functions are saved and can con
-
tinue to be displayed.
Error
codedisplay
Continuous monitoring of the components of the
FLYER e-bike system is carried out automatical
-
ly. If an error is detected, the corresponding error
code
 appears in the text display (d). Press any
button on the on-board computer (3) or on the
operating console (9) to return to the standard
display. Depending on the error type, the motor
maybeswitchedo󰀨automatically.However,you
can continue to ride without motor assistance at
all times. The FLYER e-bike must be checked be
-
fore being ridden again. The list of error codes
can
be found in the separate Intuvia operating
instructions.