Flyer UPROC - Operating the e-bike with Purion on-board computer

12
7
6
5
4
3
2
8 9 1
f
gh
a
i
b
d
e
c
j
5.2 Operating the e-bike with
 Purionon-boardcomputer
1. On/o󰀨buttonforon-boardcomputer
2. «WALK» pushing aid button
3. Fastening screw for on-board computer
4. Holder for on-board computer
5. Reduce assistance button «–»
6. Increase assistance button «+»
7. Display
8. Protective cover for USB socket
9. USB diagnostic socket (for maintenance
purposes only)
On-boardcomputerdisplayelements
a Speedometer display
b Display in km/h
c Display in mph
d Total distance indicator «TOTAL»
e Range indicator «RANGE»
f Service display
g Battery charge status indicator
h Lighting display
i Support level indicator/value display
j Trip indicator «TRIP»
Switchingon/o󰀨
The E-bike system can be switched on in the
following ways:
• With the E-bike battery inserted, press the on/
o󰀨button1 on the on-board computer.
• Press the on/o󰀨 button on the E-bike battery
(see battery operating instructions).
The drive is activated as soon as you put your
feetonthepedals(exceptforinpushingaidmode
or in support level «OFF»). The motor output is
based on the support level set in the on-board
computer.
Ifyoutakeyourfeeto󰀨thepedalsinnormaloper
-
ation, or once you reach a speed of 25/45 km/h,
the
 support is switched o󰀨 by the E-bike drive.
The drive is automatically reactivated when you
put your feet on the pedals and your speed drops
below 25/45 km/h.
The E-bike system can be switched o󰀨 in the
following ways:
• Presstheon/o󰀨button1 on the on-board com
-
puter.
•
Switch o󰀨 the E-bike battery using its on/o󰀨
button (see battery operating instructions).