Sening®
Innovative Tank Truck Systems
EPE2-
Controller for Meter Draining System
EPE2
Installation Manual
MN F08 003 US / DOK-450E Rev. 1.03 / JS / jp / March 2010 23
The seven outputs can be switched (provided the MultiFlow has not been sealed) by pressing the
corresponding number (1-7). That way a functional test of the connected device (solenoid valve) is
possible.
For safety reasons all outputs are set to '0' (inactive) on calling and on leaving
the diagnostic screen.
The assignment of the outputs to functions depends on the se
control, please refer to Parameter 3.1.8.1 and the respective circuit diagrams.
The current status of the valves must be observed without fail.
When a vehicle is operat
ional actuation of the valves can lead to escape of the
product!
To Next Page
Loading...