FMC Technologies Sening EPE2 - Default Chapter; Table of Contents

Sening®
Innovative Tank Truck Systems
EPE2-
Controller for Meter Draining System
EPE2
Installation Manual
MN F08 003 US / DOK-450E Rev. 1.03 / JS / jp / March 2010 iii of iv
Contents
1 General ....................................................................................................................... 5
1.1 Orientation aids for the manual ........................................................................... 5
1.2 Device description ................................................................................................ 6
1.3 Schematic Structure of GMVT 805 “Stand-Alone residue discharge“ ............. 7
1.3.1 “Stand-Alone residue discharge“ function ................................................................... 8
1.4 Schematic Structure of GMVT 805 “MultiFlow residue discharge“ .................. 9
1.4.1 “MultiFlow residue discharge“ function ..................................................................... 10
2 General installation instructions ............................................................................ 11
2.1 Preventive measures .......................................................................................... 11
2.1.1 For preventing accidents (caused by ignition of gases) ............................................ 11
2.1.2 To meet the requirements stipulated by standards ................................................... 11
2.1.3 To ensure trouble-free operation .............................................................................. 11
2.1.4 To make the job of the service personnel easier ...................................................... 12
2.2 Maintenance ........................................................................................................ 12
3 Commissioning ....................................................................................................... 13
3.1 Adaptation of the operating mode ..................................................................... 13
3.1.1 Operating modes ...................................................................................................... 14
3.1.1.1 “Stand-Alone residue discharge“ mode ...................................................... 14
3.1.1.2 “MultiFlow residue discharge“ mode ........................................................... 14
3.2 Switching outputs in “Stand-Alone residue discharge“ operation ................ 15
3.2.1 Switching output of the solenoid valve for the control air .......................................... 15
3.2.2 Power Out switching output for the flow computer .................................................... 15
3.3 Switching outputs for “MultiFlow residue discharge“ operation ................... 16
3.4 Setting the sensor type ...................................................................................... 16
3.4.1 Setting the sensor switching logic............................................................................. 17
3.5 Further tips for commissioning ......................................................................... 17
3.6 Components overview ........................................................................................ 18
3.6.1 Control board REC-1S ............................................................................................. 18
3.6.2 EPE2-Controller Internal overview............................................................................ 18
3.7 Parameters in MultiFflow .................................................................................... 19
3.7.1 Residue removal control with MultiFlow ................................................................... 20
3.8 Diagnosis in MultiFlow ....................................................................................... 22
3.8.1 Inputs and Outputs ................................................................................................... 22
3.8.2 CAN Bus .................................................................................................................. 24
3.8.2.1 Testing Links .............................................................................................. 24