4.3 GSM remote operation ( talk-back function added)
When alarm occurs, GSM will call the preset voice number, when pick up
the call,enter 4 digit user code, then voice prompt: Press 1 to arm system,
Press 2 to disarm system, Press 3 to Stay arm, Press 4 to check system
status, Press 5 to appliance switch control, Press 9 to talk-back, Press 0 to
Disconnect.
4.4 GSM alarm receiving (talk-back function added)
When alarm occurs, it will send SMS first, then call the preset voice number,
when pick up the call, it will play the recorded voice message first, then voice
prompt: Press1 to cancel alarm, Press 2 to check alarm event, Press 3 to arm
system,Press 4 to disarm system, Press 5 to Stay arm, Press 6 to enable siren,
Press 7 to listen-in, Press 8 to con trol programmable output port, Press 9 to
talk-back, Press 0 to Disconnect.
4.5 GSM control via SMS
Arm command: password:1234 system arm
Disamr command: password:1234 system disarm
Stay command: password:1234 system home
Cancel alarm command: password:1234 system cancel
Status checking command: password:1234 system status
Enable programmable output port command: pasword:1234 pgm open
Disable programmable output port command: password:1234 pgm close
Enable appliance switch command:
password:1234 switch open X(X=1-8 on behalf of appliance switch number)
Disable appliance switch command:
password:1234 switch close X(X=1-8 on behalf of appliance switch number)
User manual
12
Set apn:
Set ID:
Set password:
password:1234 apn: aaa
password:1234 user: bbb
password:1234 pwd: ccc
Note: the factory default user code is 1234, when arm successfully, SMS auto
reply arm successfully , if the password is correct, the command is not
correct, SMS will reply operation failure , if the password is not correct,
no SMS reply.
To Next Page
Loading...
Need help?
General