Forcepoint 330 - Interface Slot Cover and SFP Removal; Reattaching Interface Slot Cover; SFP Transceiver Removal

Forcepoint Next Generation Firewall Hardware Guide | Models 330, 331, 335, 335W
21
d) On the Prepare for Management Contact page, highlight Finish, then press Enter.
e) If the number of ports in the new module differs from the old module, modify the interface definitions in
the Management Client, then refresh the policy to transfer the interface changes to the engine.
Make sure to use the same interface IDs that you mapped to the interfaces in the NGFW Initial
Configuration Wizard for the interface definitions in the Management Client.
Reattach the cover plate to the interface
module slot
Reattach the module cover plate if there is no module in the slot.
CAUTION: Do not turn on the appliance if a slot is empty or uncovered. Using the appliance
without an interface module or the cover plate can damage the appliance and voids the warranty.
Note: We recommend fastening a grounding strap to your wrist so that it contacts your bare skin
and attaching the other end of the strap to the appliance.
Steps
1) Turn off the appliance.
2) Remove the interface module from the interface module slot.
3) Locate the tab at the lower left corner of the plate.
4) Insert the tab into the hole in the lower left corner of the slot casing.
5) Push and hold the thumbscrews on the plate, then tighten them to secure the plate in place.
Remove SFP transceivers
Remove or replace an SFP transceiver.
CAUTION: Invisible laser radiation is emitted from the end of a fiber-optic cable and from the fiber
port. Do not stare into the beam and avoid direct exposure to the beam.
Note: We recommend fastening a grounding strap to your wrist so that it contacts your bare skin
and attaching the other end of the strap to the appliance.
Steps
1) Turn off the appliance and disconnect any power cables.