Forcepoint Next Generation Firewall Hardware Guide | Models 330, 331, 335, 335W
15
Install an interface module
If needed, install any interface modules.
Before you begin
• Read the safety precautions.
• Make sure any interface modules you install are the correct type for your appliance.
CAUTION: To avoid damaging the modules or the appliance, do not install or remove any
interface modules if the appliance is turned on.
You must install an interface module or a placeholder module in each slot before making the appliance
operational. If the appliance was delivered with a plate that covered the interface slot, you can cover the interface
slot with the plate.
Note: We recommend fastening a grounding strap to your wrist so that it contacts your bare skin
and attaching the other end of the strap to the appliance.
Steps
1) Locate the slot to install the module in.
2) If the interface slot is covered with a plate, unfasten the thumbscrew that attaches the plate to the interface
module slot and remove the plate.
Store the plate and the thumbscrew for later use in case you want to use the appliance without an interface
module.
3) Push the module into the slot.
The module is seated correctly when the front panel of the module is even with the front panel of the
appliance.
Important: Do not insert the module in the wrong orientation. Inserting the modules
incorrectly might damage the appliance and the modules and voids the warranty.
4) Push and hold the thumbscrews on the module, then tighten them to secure the module in place.
To Next Page
Loading...
