Ford 1996 Explorer - To Remove the Child from the Built-In Child Seat; To Fold up the Built-In Child Safety Seat

Safety Restraints
51
*
[SR15257( X)08/95]
To remove the child from the built-in child seat:
[SR15258( X)10/94] 1. Open the chest clip. Refer back to Figure 9.
[SR15260( X)08/94] 2. Press release button on the crotch safety buckle. Refer back
to Figure 8.
[SR15265( X)08/94] 3. Slide the shoulder safety belts off the child’s shoulders and
remove the child from the seat. Refer to Figure 6.
[SR15270( X)01/95]
To fold up the built-in child safety seat:
[SR15271( X)06/95]
Make sure belts have fully retracted to the stowed position
before stowing the child safety seat.
[SR15273( X)02/96]
NOTE: The seatback cannot be folded down unless the child
safety seat is fully stowed.
[SR15275( X)08/94] 1. Fold the protector flap over the child’s seat cushion. Refer to
Figure 5.
[SR15280( X)08/94] 2. Rotate the child seat cushion upward, securing both velcro
straps. Refer to Figure 4.
[SR15285( X)08/94] 3. Slide the head restraint down until it is flush with the top of
the adult seatback. Refer to Figure 4.
[SR15290( X)09/95]
NOTE: When the child’s safety seat is not in use, it may be
folded up so that an adult may use the vehicle’s rear
seat. Refer to Figure 1.
File:03unsrx.ex
Update:Thu Feb 29 09:02:31 1996