Note: Make sure the modular roof panel
slides back into place and the locating pins
sit in the front latch receiver when installing
the modular roof panel.
Note: You do not need to pull and hold the
spring-loaded slides to turn the latches to
lock the modular roof panel.
REMOVING AND INSTALLING THE
REAR ROOF PANEL - 4-DOOR
Remove the front panels and center panel
before removing the rear roof panel.
1. Open the rear doors.
2. Open the tailgate window. See
Opening and Closing the Windows
(page 103).
3. Locate the wire harness and washer
hose on the driver side rear inside
corner of the vehicle.
4. Release the locking tab by pushing it
down.
5. Push the tab inward when pulling down
to disconnect and remove the wiring
harness.
6. Push the release button on the hose
connector and pull down to remove
the washer hose.
7. Secure the wiring harness to the body
side by plugging it into the receptacle
and pushing up on the locking tab.
8. Secure the washer hose by snapping it
into the top of the body side
receptacle.
9. Remove the two fasteners that secure
the rear roof panel at the C-pillar using
the provided head driver and ratchet.
346
2021 Bronco (TG1) Canada/United States of America, enUSA, Edition date: 202101, First-Printing
Removable Vehicle Components
To Next Page
Loading...
