Ford Bronco 2021 - Page 361

Storing the Front Roof Panels and
the Front Doors
1. Adjust the seat backrest to the optimal
seating position. Pull the lever up, and
push the backrest rearward when
storing the two front doors. This
creates more space between the front
door sail and the upper trim. Ensure the
cargo area is clear of any other items.
See Adjusting the Seat Backrest
(page 134).
2. See Securing the Door Retention
Harness earlier in this chapter and
complete Steps 1-7.
3. Open the passenger side front door and
install the door bag. See Removing
and Installing the Doors (page 339).
E346666
4. Zip the bag fully closed and gently
place the door in the cargo area. Avoid
contacting the rear pillars, speakers,
striker, and trim.
5. Slide the door into position with the
bag label facing rearward. Center the
door to make sure there is space
between the door and cargo box trim
panels.
6. Push the lower edge of the door
forward until it stops to create space
for the door peak.
7. Secure the door bag to the retention
harness with the clip.
8. Repeat Steps 3-5 for the driver side
front door. Secure the bags using the
clips on the bags.
9. Place the front roof panels in the bag,
and then into the cargo area. See
Storing the Doors and the Roof
Panels (page 352).
Note: Do not use the roof bag retention
system in this orientation. Secure the roof
panels by the harness.
10. Lift the retention harness over the
doors. Make sure the straps are
straight.
11. Secure the upper straps 5 and 6 to
the eyelet bolts and lower straps 7
and 8 to the rear cargo rings.
12. Tighten all adjustable straps to
secure the doors and roof panels.
Note: The doors and roof panels should not
move when pressure is applied.
Storing all Four Doors
1. Adjust the rear seat backrest to the
upright position and raise the center
headrest to the highest position. Pull
on the seat backrest to make sure that
it has fully latched. Ensure the cargo
area is clear of any other items. See
Adjusting the Seat Backrest (page
134).
357
2021 Bronco (TG1) Canada/United States of America, enUSA, Edition date: 202101, First-Printing
Removable Vehicle Components