• before starting
• after driving 50 kilometers (30 miles)
• at 1000 kilometers (600 miles)
intervals.
To reduce fuel consumption, cross rails
should be removed when not in use.
Installing the crossbars
WARNING
Distribute the load evenly over the
loading area and keep the center of
gravity as low as possible. Secure the
load well to prevent it from slipping. Never
place any loads directly onto the roof
surface.
CAUTION
Remove the crossbars before entering
an automatic car wash.
Note: The side mounting tracks are
designed such that crossbars (for bicycle
carriers, ski carriers etc.) from the Ford
accessories range can be fitted.
Note: Before installing the crossbars, clean
the side mounting tracks with water and a
sponge.
Note: Position the crossbars as shown.
120 mm (4.7 inches)A
800 mm (31.5 inches)B
Note: Adhesive pads are supplied to help
reduce the buffeting noise.
Note: Make sure the surface of the
crossbars is clean before attaching the
adhesive pads.
1. Remove the backing and attach the
adhesive pads to the crossbars in the
positions shown.
2. Pull the handle out.
3. Turn the handle clockwise to bring the
crossbar in contact with the rail.
169
C-MAX (CB7)
Load Carrying
To Next Page
Loading...
Need help?
General
