Ambient lighting illuminates several areas,
for example footwells, cup holders and
doors with a single color and can be
switched on and off using the information
display menu. See General Information
(page 81).
Use the instrument lighting dimmer
switches to adjust to the desired
brightness. See Instrument Lighting
Dimmer (page 118).
REMOVING A HEADLAMP
WARNING
Have Xenon bulbs changed by a
trained technician. There is a risk of
electric shock.
1. Open the hood. See Opening and
Closing the Hood (page 188).
2. Remove the screws.
3. Pull the headlamp as far as possible
towards the center of the vehicle to
disengage it from the lower fixing point.
4. Lift the outer side of the headlamp and
remove it.
5. Disconnect the electrical connector.
Note: When fitting the headlamp, make
sure that you reconnect the electrical
connector properly.
Note: When fitting the headlamp, make
sure that you fully engage the headlamp in
the lower fixing point.
Note: When fitting the headlamp, make
sure that the screw is located in the
headlamp molding before you install it.
CHANGING A BULB
WARNINGS
Switch the lights and the ignition off.
Let the bulb cool down before
removing it.
Have Xenon bulbs changed by a
properly trained technician. There is
a risk of electric shock.
60
C-MAX (CB7)
Lighting
To Next Page
Loading...
Need help?
General
