High sensitivityA
OnB
Low sensitivityC
If you switch autowipers on, the wipers will
not cycle until water is detected on the
windshield. The rain sensor will then
continuously measure the amount of water
on the windshield and adjust the speed of
the wipers automatically.
Adjust the sensitivity of the rain sensor
using the rotary control. With low
sensitivity, the wipers will operate when
the sensor detects a lot of water on the
windshield. With high sensitivity, the wipers
will operate if the sensor detects a small
amount of water on the windshield.
WINDSHIELD WASHERS
WARNING
Do not operate the washer for more
than 10 seconds at a time, and never
when the reservoir is empty.
Whilst the lever is pulled towards the
steering wheel the washer will work in
conjunction with the wipers.
After releasing the lever, the wipers
operate for a short time.
REAR WINDOW WIPER AND
WASHERS
Intermittent wipe
Intermittent wipeA
Low speed wipeB
Press the button at the end of the lever to
change between off, intermittent and low
speed.
Reverse gear wipe
The rear wiper will be activated
automatically when selecting reverse gear
if the rear wiper is not already switched on
and the front wiper is operating.
49
C-MAX (CB7)
Wipers and Washers
To Next Page
Loading...
Need help?
General
