• You must replace the sealant bottle
with a new one before the expiry date
(see top of bottle).
• Inform all other users of your vehicle
that the tire has been temporarily
sealed with the kit. Make them aware
of the special driving conditions to be
observed.
Inflating the tire
WARNINGS
Check the sidewall of the tire prior to
inflation. If there are any cracks,
bumps or similar damage, do not
attempt to inflate the tire.
Do not stand directly beside the tire
while the compressor is pumping.
Watch the sidewall of the tire. If any
cracks, bumps or similar damage
appear, turn off the compressor and
let the air out by means of the pressure
relief valve B. Do not continue driving with
this tire.
The sealant contains natural rubber
latex. Avoid contact with skin and
clothing. If this happens, rinse the
affected areas immediately with plenty of
water. Consult a physician if you
experience an adverse reaction.
If the tire inflation pressure does not
reach 1.8 bar (26 psi) within 10
minutes, the tire may have suffered
excessive damage, making a temporary
repair impossible. In this case, do not
continue driving with this tire.
Screwing the bottle onto the bottle
holder will pierce the seal of the
bottle. Do not unscrew the bottle
from the holder as the sealant will escape.
Protective capA
Pressure relief valveB
HoseC
Orange capD
Bottle holderE
Pressure gaugeF
Power plug with cableG
Compressor switchH
LabelI
Bottle lidJ
Sealant bottleK
1. Open the lid of the tire repair kit.
210
C-MAX (CB7)
Wheels and Tires
To Next Page
Loading...
Need help?
General
