When you are jacking a flat front tire,
connect the extension block to the jack
loadrest using the wing bolt as shown.
Connect the jack handle to the jack, and
use the lug nut wrench to operate the jack.
Note: Do not use the extension block when
you are changing a flat tire on the rear of the
vehicle. Assemble the jack handle using the
extensions as shown to operate the jack
when placing under the rear axle.
1. Place the vehicle jack at the jacking
point next to the tire you are changing.
2. Assemble the jack handle, including
the required extension tubes depending
on the position you are jacking, and turn
the jack handle clockwise until the
wheel is completely off the ground.
Note: When changing the rear flat tire,
connect all the handles together to extend
the jack handle.
468
2024 Ranger (TRD) Canada/United States of America, enUSA, Edition date: 202304, DOM
Changing a Road Wheel
To Next Page
Loading...
