System Configurations Summary
l Red: Failed WAN link
WAN Link State
WAN : Enabled WAN Link.
State : Current connection status.
IPv4 / IPv6 Address :
The IPv4 or IPv6 address of the WAN port (See "Configuring your WAN").
Note
The notes for the WAN link (See "Configuring your WAN").
Get system information, peer information and WAN link state via SNMP
You can use SNMP manager to get the system information, HA peer information and WAN link state. Configure SNMP
for your FortiWAN unit (See "SNMP") and you can get the information in a MIB field via SNMP manager. The
correspondent MIB fields and OIDs are listed as following:
SNMP field names and OIDs
MIB Field OID Description
fwnSysSlaveVersion 1.3.6.1.4.1.12356.118.1.2 Firmware version of the slave unit
deployed with this local unit in HA
mode.
fwnSysSlaveSerialNumber 1.3.6.1.4.1.12356.118.1.3 Serial number of the slave unit
deployed with this local unit in HA
mode.
fwnSysSlaveUptime 1.3.6.1.4.1.12356.118.1.4 Uptime of the slave unit deployed
with this local unit in HA mode.
fwnSysSlaveState 1.3.6.1.4.1.12356.118.1.5 State of the slave unit deployed
with this local unit in HA mode.
fwnSysConnections 1.3.6.1.4.1.12356.118.1.6 Number of connections that are
being processed in the system.
fwnSysCpuLoad 1.3.6.1.4.1.12356.118.1.7 Current CPU load (in percentage) of
the system.
fwnSysUsers 1.3.6.1.4.1.12356.118.1.8 Number of IP addresses connecting
to the FortiWAN unit from the LAN
and DMZ subnets.
fwnSysPktPerSec 1.3.6.1.4.1.12356.118.1.9 Number of packets transferred via
the system every second.
96 FortiWAN Handbook
Fortinet Technologies Inc.
To Next Page
Loading...
