Enable timing to capture
To enable capture interval, follow the steps below:
1 Select Enable Motion detection
2 Capture interval: The interval time between two captures.
3 Select the capture time
Click the black button up the MON, you will see all time range turn red. When something moving in
the detection area at anytime, the camera will capture.
Specify an capture schedule
Click the week day words, the corresponding column will be selected. For example, click TUE, the
all column of TUE turns to red, that means during Tuesday whole day, the camera will capture.
Press the left mouse and drag it on the time boxes, you can select the serial area,
4 Click Save button to take effect.
4.6 Detector
4.6.1 Motion Detection
IP Camera supports Motion Detection Alarm, when the motion has been detected, the IP Camera will
make a alarm.
Step 1: Enable motion detection function.
Step 2: Sensitivity---- It supports five modes: Lowest, Lower, Low, Medium and High. The higher the
To Next Page
Loading...
