Foscam FI9803P - 5.2 Default Parameters; 5.3 Specification

w
w
www
www
.foscam.
.foscam.
us
us
Foscam Digital Technologies LLC
Telephone: 1-800-930-0949
67
5.1.8 UPnP always failed
UPnP only contains port forwarding in our recent software. Sometimes, it may be failed to do port forwarding
automatically because of firewall or anti-virus software. It also has much relation with router’s security settings.
So we recommend you do port forwarding manually. You can view your camera in internet successfully after
you do port forwarding manually in your router.
5.1.9 Camera can not connect wireless
If your camera could not connect wireless after you set wireless settings and plug out the cable. Please check
whether your settings are correct or not.
Normally, camera can’t connect wireless mainly because of wrong settings.
Make sure broadcast your SSID; use the same encryption for router and camera.
5.2 Default Parameters
Default network Parameters
IP address: obtain dynamically
Subnet mask: obtain dynamically
Gateway: obtain dynamically
DDNS: Embedded FOSCAM DDNS Service
Username and password
Default username is admin with a blank password
5.3 Specification
ITEMS
FI9803P
Image Sensor
Sensor
High Definition Color CMOS Sensor
Display Resolution
1.0 Megapixels
Min. Illumination
0 Lux (With IR Illuminator)
Lens
Lens Type
Glass Lens
focal length
f: 2.8mm
Aperture
F1.2
Diagonal angle of view
75°
Horizontal view angle
70°
Image Compression
H.264
Frame rate
25fps（VGA）, 23fps（720P）
Stream
dual stream