Foss NIRS DA1650 User Manual

NIRS™ DA1650
User Manual 6008 1286 / Rev. 8 4:1
4 Operating Instructions
4.1 Routine Start-up
1. Turn on the analyzer by pressing the On/Off switch placed at the rear of the
instrument.
The analyser will now start up, initializing the software. This will take several
minutes. Once the software is ready, the instrument will go through the start-up tests.
The instrument is ready for analysis when the start-up test has succeeded.
Fig. 4:1
If the startup test fails you should create a diagnostic report to obtain and document
the information about why it failed.
This report is created via the Report button in lower left-hand corner - select the
built-in diagnostic report and press Save.
Fig. 4:2
The report is now stored as a pdf-file in the location specified in the Configuration
view (see section
4.3.11 Configuration).

Foss NIRS DA1650 Specifications

General

Brand	Foss
Model	NIRS DA1650
Category	Measuring Instruments
Language	English