NIRS™ DA1650
4:6 User Manual 6008 1286 / Rev. 8
4.2.3 Multi-cup Analysis
For some sample types it is desired to split a larger sample volume into sub-samples
and report the results as the average of these sub-samples. This is support in NIRS
DA1650 via the Multi-cup analysis. In the Operation Profile in FossManager you
set the number of sub-samples (repetitions) for the product in question. In ISIscan
Nova this is indicated together with the product name.
Fig. 4:10
Press Start to run the first cup and wait for the message to continue with the next cup/
sample. After scanning all cups the results are presented as the average of all sub-
scans. Results of the individual cups are not presented.
Fig. 4:11
4.2.4 Turning off the Analyser
When the instrument has been switched on, it takes about 30 minutes for it to warm
up for the first analysis.
The instrument can be left switched on over night. If left unattended over a longer
period of time (weekends/vacations), it is recommended to turn it off.
To turn off the analyser:
1. Go to the Care Menu.
2. Press SHUT DOWN.
3. Press OK to shut down instrument.
To Next Page
Loading...
Need help?
General
