NIRS™ DA1650
User Manual 6008 1286 / Rev. 8 5:3
3. Carefully turn the lamp assembly and remove it from the instrument.
4. Use the supplied flat bladed screwdriver to loosen the two screws holding the
lamp cables.
Fig. 5:2Removing lamp from cover plate
5. Fit the new lamp and assemble in reverse order.
Note: Push the cables in when you fit the lamp assembly back in
place. Make sure the cables are not squeezed.
5.5 FOSS Preventive Maintenance Agreement
Apart from regular user maintenance, FOSS also recommends that preventive
maintenance is performed at intervals according to the Preventive Maintenance
Protocol (see the Owner's Guide). During this maintenance all critical components
are replaced before they are worn out and have a negative impact on more complex
and expensive parts. This will help prevent unexpected downtime and also ensure
quality and consistency of results at the highest level. Contact your local FOSS
representative for preventive maintenance.
FOSS offers a wide range of local support products and training adapted to your
market requirements. Please contact the local FOSS representative for a tailor-made
package to fit your specific needs.
To Next Page
Loading...
Need help?
General
