DMT-8 Ver 2.0 Supplement to the Owner’s Manual
14
The following paragraphs regarding Setup mode explain changed or added
functions in Version 2.0.
Now you can select whether you wish to save only the currently-selected Program
or all the Programs (Programs 1-5).
You can set the MTC offset value in sub-frame units.
3. Changed and Added functions in Setup mode
* "SAvE" (saving data to an external DAT recorder) has been extended.
* "MTC OFFSET" (setting an MTC offset value) precision has been improved.
You can route digital signals from thee DATA IN connector (16-bit, 44.1kHz, S/P DIF
format) to any two tracks for digital recording.
* "dG in" (selecting a digital input channel) has been added.
You can select Tracks 1-2, 3-4, 5-6, 7-8 or mixer stereo L/R outputs signals from
the DATA OUT connector (16-bit, 44.1kHz, S/P DIF format).
* "dG out" (selecting a digital output channel) has been added.
You can operate the DMT-8 in Slave mode by sending the MTC and digital signals
from the MIDI OUT connector of a master DMT-8 or D-80.
* "SLAvE" (selecting Slave mode ON/OFF) has been added.
This function allows you to set receive device number (linked to the transmit device
number) used for controlling the DMT-8 via MMC (MIDI Machine Control) or FEX
(Fostex System Exclusive Message).
* "dEvicE" (selecting a device ID) has been added.
In addition to the Undo/Redo function for editing and for Auto Punch In/Out
recording, the Undo/Redo function for direct recording (normal recording
performed by pressing the REC button while holding down the PLAY button) is now
available.
* "Undo" (selecting an effective range of the Undo function) has been added.
To Next Page
Loading...
