Fostex DMT-8 - Status Request Commands

DMT-8 Ver 2.0 Supplement to the Owner’s Manual
36
The command for setting the metronome on/off of D-80/DMT-8 ver2.0.
When ON is set, the metronome signal will be fed to the track 8 output (analog output
only) of D-80/DMT-8 ver2.0.
13 44 (<on/off>): click on/off command
The command inquiring the loop operation mode setup status.
D-80/DMT-8 ver2.0 will reply with "32 21 (<loop op. moded=12>)."
22 21: loop operation status request
The command inquiring the loop on/off (=ON/OFF of AUTO RETURN) setup status.
D80/DMT-8 ver20. will reply with "32 22 (<on/off>)."
22 22: loop on/off status request
The command inquiring the post locate mode (ON/OFF of AUTO PLAY)setup status.
D-80/DMT-8 ver2.0 will reply with "32 28 (<post locate mode>)".
22 28: post locate status request
The command inquiring the slave on/off setup status and the lock status.
D-80/DMT-8 ver2.0 will reply with "32 41 (<lock status>)."
22 41: lock status request
The command inquiring the clipboard condition. If there is a copy paste data in the
clipboard, D-80/DMT-8 ver2.0 will reply with "32 45 (<edit message-01>).
If data in the clipboard is for move paste or there is no valid data in it, it will reply will
"32 45 (<edit message=14 (void data)>)."
22 45: copy clip status request
The command inquiring execution status of copy paste editing.
When this command is received, D-80/DMT-8 ver2.0 will reply with either "32 46 (<edit
message=02><mmc time>)" or "32 46 (<edit message=00>). <mmc time> indicates
unprocessed time until completion.
22 46: copy paste status request
The command inquiring execution status of erase.
When this command is received, D-80/DMT-8 ver2.0 will reply by either "32 47 (<edit
message=02><mmc time>)" or "32 47 (<edit message=00>)." <mmc time> indicates.
unprocessed time until completion.
22 47: erase status request
The command inquiring the auto rec mode setup status and this is replied by "32 2D
(<edit message>). Reply from D-80/DMT-8 ver2.0 against this status request will be
either one of the following:
<edit message> =05: Possible to undo rehearsal mode.
=06: Possible to undo take mode.
=25: Impossible to undo rehearsal mode.
=26: Impossible to undo take mode.
=72: off
22 2D: auto rec status request
The Status Request Command