To Next Page

To Previous Page

DMT-8 Ver 2.0 Supplement to the Owner’s Manual

The Program Change function allows you to select any of five Programs (1-

5) to which the hard disk apace is allotted, so you can record, playback,

eddit, and archives up to five songs individually on a single hard disk (as

long as there is adequate free space on the disk). You can create an

individual song, so that for example the first song is in Program 1, the

second song in Program 2 etc.

1. Program Change function

To perform recording, playback , edit, and archives, first select a desired

Program.

* You can select a Program any time other than when the recorder

section is in REC mode or PLAY mode.

When you turn on the power to the DMT-8, a Program with the

Time Base used before you turned off the power will be selected.

(When you turn on the power to the unit for the first time after

unpacking, the DMT-8 will start with Program 1 with "ABS TIME"

base.) Make sure that the DMT-8 is stopped when you select a

Program.

Here, let’s assume that Program 1 with "ABS TIME" display was selected

when you turned on the power to the DMT-8.

1. While the screen shown above is displayed, pressing the STORE key

while holding down the HOLD/> key and repeatedly to switch Programs

from P1 through P5.

The following figure indicates that each Program with a Time Base of

"ABS" is selected.

How to switch a Program

ABS

Displayed Program Number

ABS

Fostex DMT-8 User Manual

Other manuals for Fostex DMT-8