Fostex DMT-8 - Page 35

DMT-8 Ver 2.0 Supplement to the Owner’s Manual
35
When this command is received, D-80/DMT-8 ver2.0 will copy (multiple tracks can be
copied simultaneously) the sound data from the pre-regisered clipboard in point to the
clipboard out point, as data for move paste operation.
With completion copying the data into the clipboard, D-80/DMT-8 ver2.0 will immediately
reply with "32 4D (<edit message=01 (completed)>)."
If copy cannot be executed by the reason of pre-registered improper clipboard in/clipboard
out point figures or incorrect track section etc., the corresponding <edit message> will
be replied.
12 4D (<count><mmc track>): move clip command
When this command is received, D-80/DMT-8 ver2.0 will paste the sound data which
have been move clipped in the clipboard, for the number of times specified by <repeat
count> on the same track from the pre-registered auto punch in point as the starting
point.
At the same time, the move clipped original sound data will be erased (data "0" is written
in). However, when sound data length in the clipboard is less than 10ms, specifying
the <repeat count> will be limited to "01."
Also, by specifying the <mmc track> paste operation can be executed on other tracks in
mono (one track unit) or stereo units (tracks 1 & 2, 3 & 4, 5 & 6, 7 & 8).
Since time corresponding to length of the move clipped sound data is required to complete
the move paste operation, D-80/DMT-8 ver2.0 will immediately reply with "32 4E (<edit
message=02 (active)>)" after receiving the command.
Following completion of the move paste operation, "32 4E (<edit message = 01
(completed)>)" will be sent.
If paste cannot be executed due to improper figures of the previously registered auto
punch in point, insufficient disc capacity, no sound data is in the clipboard, etc., the
corresponding <edit message> will be replied.
12 4E(<count=1><repeat count>): move paste command
12 4E (<count><repeat count><mmc track>): move paste command
The command assigning the digital audio signal (S/P DIF) input from the D-80/DMT-8
ver2.0 DATA IN connector to the track specified by <channel>. The digital audio signal
L channel assignment point is specified by the first <channel> and the R channel
assignment point by the second ,channel> in the command. If the same figure is specified
for both <channels>, L channel will have priority and R channel will be "-" (invalid).
13 41 (<channel><channel>): digital in ch. select command
This command selects the source track for the digital audio signal (S/P DIF) output from
the D-80/DMT-8 ver2.0 DATA OUT connector.
Normally, the track specified by the first <channel> will be the digital audio signal L
channel data, and the track specified by the second <channel> will be the digital audio
signal R channel data. In this equipment, the five types - (<01><02>), (<03><04>),
(<05><06>), (<07><08>) and (<00><00>) -can only be set up. Also, when (<00><00>) is
specified, default (L:-, R-, No Assign) will be set up in D-80, and (L:L, R:R) will be set up in
DMT-8 ver2.0. Thus the mixer section stereo bus output will be assigned on DMT-8
ver2.0.
13 41 (<channel><channel>): digital out ch. select command
The command for PROGRAM CHANGE of D-80/DMT-8 ver2.0
The present program number can be changed to the figure indicated by <program>.
13 43 (<program>): program change command